DIY Knock Off Faux Reclaimed Wood Emmerson West Elm Benches

Yesterday we told you about how we built a DIY knock off faux reclaimed wood table modeled after the Emmerson table from West Elm. Well what good is a table if you don’t have anywhere to sit? That’s why we also made DIY knock off faux reclaimed wood benches to model off their waterfall benches!

Click here to pin this project to your pinterest board!

I’ll admit- I had a lot more problems building these benches than I did with the table, but it shouldn’t have been that way. I just kept running out of wood for some reason. Even though I did the math, I ended up with issues. I also had to make some design changes halfway through the first bench that required another trip to the store to figure that out. In the end, no real problems.

DIY Knock Off Faux Reclaimed Wood Emmerson West Elm Benches

I built the bench using the same system as the table. I started with the bench top using two 63″ 2x4s and five 7″ 2x4s. Using a Kreg jig, I created the rectangular top with the 7″ pieces in between starting on the edges and putting the three others evenly spaced.

I made the legs in a box frame with 14″ pieces on the top and bottom with 13.75″ pieces going up. I secured them with deck screws and then put them on the ends of the bench top.

The best tip I have for attaching something like this is to angle your screws in opposite directions and drive them in at angles instead of driving them straight down.

With the frame built, it was time to add the 1×4 paneling. The top of the frame was four 1x4s across, all cut at different lengths in order to give it the look of various pieces of wood. Each piece of wood was stained in one of four colors in alternating spots. The pieces on the ends had a 45 degree mitered cut to align with the pieces that would be coming up the side.

After attaching the top, we added the pieces to the outside to create a waterfall look. This was the main difference between the benches and the table. The waterfall look gives the benches a look of a continuous piece of wood going down the side.

After the outside end pieces were on, we added straight cut pieces to the inside of the leg frame to fill it in.

Finally came the outside sides. We cut pieces to the same lengths as the top pieces so that they would look like a 4×4 piece of wood coming down. We gave these a beveled 45 degree cut to angle with the legs coming up the sides.

The final four pieces of wood were 1×2 pieces of pine that covered the last bit of a corner and made seamless boxes for the legs.

In the end, the entire thing looks beautiful. The waterfall sides look so good and refined.

Click here to pin this project to your pinterest board!

Here’s how we made the matching table

The wood for these benches cost about $200. This is pretty good compared to the fact that each bench from West Elm cost between $500-600 depending on which size you got. So yeah, between the table and benches, we spent around $500. Seems like a lot until you compare the fact that the table and benches we modeled them after would have cost us approximately $2,300.

If you like this project you might also like:

Live edge slab coffee table

Driftwood coffee table

Pipe leg bench

Morgan

Hello, I’m Morgan, half of the creative force behind CharlestonCrafted.com! With a passion for DIY that dates back to 2012, I’ve transformed three homes and now I’m dedicated to helping others craft their dream spaces. Let’s turn your house into a home together!